Jam Protection Function does not Operate: Procedure

PERFORM INITIALIZATION (APPLICABLE LOCATION)
1. Initialize the power window regulator motor assembly (applicable location). Refer to INITIALIZATION [08/2012 - ] .
NEXT: Go to next step
CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION)
1. Check if the power window auto up and down functions operate normally. Refer to OPERATION CHECK [08/2012 - ] .
  OK
  
  Auto up and down functions are normal.
NG → See step 4

OK: Go to next step

CHECK JAM PROTECTION FUNCTION OPERATING RANGE

Check if the jam protection function operates normally for the applicable power window.

HINT:

The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.

Jam protection function operates normally.

Result

Result	Proceed to
OK	A
NG (Driver door power window)	B
NG (Front passenger side power window)	B
NG (Rear LH side power window)	C
NG (Rear RH side power window)	C

B → See step 5

C → See step 6

A → END (PROBLEM DUE TO INITIALIZATION FAILURE)

GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table). Refer to PROBLEM SYMPTOMS TABLE [08/2012 - ]
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Side or Front Passenger Side). Refer to REMOVAL [08/2012 - ]
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Side or Rear RH Side). Refer to REMOVAL [08/2012 - ]