LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2013 >> IS F >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Registration >> Register Transmitter ID
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Register Transmitter ID

  1. Set the tire pressure of all wheels to pressure specified on the tire and loading information label.
  2. Connect the Techstream to DLC3 (located under steering column).
  3. With the vehicle stopped and parking brake applied, turn the ignition switch ON. Turn Techstream ON.
  4. Perform the transmitter ID registration. Enter the following menus: Chassis / Tire Pressure Monitor / Utility / ID Registration.
    NOTE: If the system is in the initialization mode, it is unable to perform registration. Therefore, restart the registration after terminating the initialization or confirming that the initialization has been completed.
  5. Using the TPMS Selector Switch, select the "MAIN" registration mode (or "2nd" if registering in 2nd mode).
    NOTE: TPMS Selector Switch button operation: See Figure.
    • 1 -  Press "<" or ">" repeatedly until the setting "Tire Select" display appears.
    • 2 -  Press the "ON/OFF" button to switch between "MAIN" and "2nd" ID codes.
  6. Input the transmitter IDs (ID1 to ID4) using the Techstream and transmit it to the tire pressure monitor ECU.
  7. The "ID Registration is complete" will be displayed on the Techstream display.
NOTE: *The tire pressure warning light will continue to blink until the tire pressure warning ECU and receiver receives the input ID signals.
scientia non olet · About LEMON Manuals