Installation [04/2013 - ]: Procedure
- INSTALL ACCELERATION SENSOR
- Install the acceleration sensor with the 2 nuts.
Torque: 8.5 N.m (87 kgf/cm, 75 in.lbf)
NOTE:- Avoid any impact to the acceleration sensor.
- Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
- Connect the connector.
- Return the floor carpet to its original position.
- Install the acceleration sensor with the 2 nuts.
- INSTALL FRONT DOOR OPENING TRIM COVER LH
Refer to PROCEDURE - Step 28 [04/2013 - 08/2015] , or refer to PROCEDURE - Step 28 [08/2015 - 10/2016] , or refer to PROCEDURE - Step 28 [10/2016 - 09/2020] , or refer to PROCEDURE - Step 28 [09/2020 - ]
- INSTALL FRONT DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 29 [04/2013 - 08/2015] , or refer to PROCEDURE - Step 29 [08/2015 - 10/2016] , or refer to PROCEDURE - Step 29 [10/2016 - 09/2020] , or refer to PROCEDURE - Step 29 [09/2020 - ]
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [04/2013 - 06/2014] , or refer to INITIALIZATION [06/2014 - 08/2015] , or refer to INITIALIZATION [08/2015 - 10/2016] , or refer to INITIALIZATION [10/2016 - 10/2017] , or refer to INITIALIZATION [10/2017 - 09/2020] , or refer to INITIALIZATION [09/2020 - 11/2021] , or refer to INITIALIZATION [11/2021 - 09/2022] , or refer to INITIALIZATION [09/2022 - 10/2023] , or refer to INITIALIZATION [10/2023 - ]