DTC P060B: Internal Control Module A/D Processing Performance [08/2014 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs (See article. Refer to DTC CHECK / CLEAR [08/2014 - ] ).
5. Turn the power switch off.
6. Turn the Techstream off.
7. Disconnect the Techstream.
8. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.
9. Connect the cable to the negative (-) auxiliary battery terminal.
10. Connect the Techstream to the DLC3.
11. Turn the power switch on (IG).
12. Turn the Techstream on.
13. Wait 16 seconds or more.
14. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
15. Read the DTCs.
    RESULT
    
    

    Result	Proceed to
    DTC is not output	A
    DTC P060B is output	B
    DTC P060B and P0327 or P0328 are output	C

Result:  A

A 

CHECK FOR INTERMITTENT PROBLEMS 

(See article. Refer to CHECK FOR INTERMITTENT PROBLEMS [08/2014 - ] )

Result:  B

B 

REPLACE ECM 

(See article. Refer to REMOVAL [08/2014 - ] )

Result:  C

C 

GO TO DTC P0327 AND P0328 

(See article. Refer to DTC P0327: Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor); DTC P0328: Knock Sensor 1 Circuit High Input (Bank 1 or Single Sensor) [08/2014 - ] )