DTC P062F: Internal Control Module EEPROM Error [08/2014 - ]: Procedure
- READ OUTPUT DTC (DTC P062F)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Clear the DTCs (See article. Refer to DTC CHECK / CLEAR [08/2014 - ] ).
- Turn the power switch off.
- Turn the Techstream off.
- Disconnect the Techstream.
- Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.
- Connect the cable to the negative (-) auxiliary battery terminal.
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Put the engine in inspection mode (maintenance mode) (See article. Refer to INSPECTION MODE PROCEDURE [08/2014 - ] ).
- Start the engine and wait 30 seconds or more.
- Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
- Read the DTCs.RESULT
Result Proceed to DTC is not output A DTC P062F is output B
Result: A
A
CHECK FOR INTERMITTENT PROBLEMS
(See article. Refer to CHECK FOR INTERMITTENT PROBLEMS [08/2014 - ] )
Result: B
B
REPLACE ECM
(See article. Refer to REMOVAL [08/2014 - ] )