Installation [09/2014 - 10/2015]: Procedure

INSTALL INJECTOR DRIVER

NOTE:

Be careful not to drop or strike the injector driver.
The injector driver is grounded at the bolt and nut. To ensure that it is grounded, clean all oil and foreign matter from the installation areas of the injector driver and engine before installing the injector driver.

Install the injector driver with the bolt and 2 nuts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)

Connect the 4 connectors to the injector driver. Move the lock levers in the direction indicated by the arrow to lock the 3 connectors.

TEXT IN ILLUSTRATION

*1	Lock Lever

INSTALL NO. 1 ENGINE COVER
1. Install the No. 1 engine cover with the 3 clips.
INSTALL NO. 1 AIR CLEANER INLET
Refer to PROCEDURE - Step 87
INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 119
INSTALL COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 120
INSTALL ENGINE ROOM SIDE COVER
Refer to PROCEDURE - Step 121
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2014 - 10/2015] ).