Installation [09/2014 - 10/2015]: Procedure

INSTALL NO. 2 ECM BRACKET
1. Install the No. 2 ECM bracket with the 2 screws.
  Torque: 3.0 N*m (31 kgf*cm, 27 in.*lbf)
INSTALL ECM BRACKET
1. Install the ECM bracket with the 2 screws.
  Torque: 3.0 N*m (31 kgf*cm, 27 in.*lbf)
INSTALL ECM
1. Install the ECM with the 2 nuts.
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
  NOTE:
  - Install the ECM to the ECM box with the name plate facing the outside of the vehicle.
  - Make sure that there is no foreign matter on the gasket surface of the ECM box.
  - Insert the stud bolt on the vehicle rear side to the ECM first.
  - Make sure that stud bolts are securely installed into the front and rear bolt holes.
CONNECT WIRE HARNESS
1. Connect the 6 ECM connectors.
  NOTE:
  Be sure to securely connect the connector.
2. Connect the connector holder to the ECM box.
3. Connect the junction connector to the connector holder.
4. Connect the 2 connectors.
INSTALL ECM COVER
1. Install the ECM cover with the 3 bolts.
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
  
  NOTE:
  Make sure that the wire harness does not get caught between the parts.
INSTALL COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 120
INSTALL ENGINE ROOM SIDE COVER
Refer to PROCEDURE - Step 121
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2014 - 10/2015] ).
PERFORM INITIALIZATION
(Refer to INITIALIZATION [09/2014 - 10/2015] )