DTC P060B: Internal Control Module A/D Processing Performance [10/2014 - ]: Procedure
- CHECK DTC
- Clear DTCs. Refer to DTC CHECK / CLEAR [10/2014 - ] .
- Disconnect the cable from the negative (-) battery terminal and wait for 1 minute. Refer to PRECAUTION [10/2014 - ] .
- Connect the cable to the negative (-) battery terminal. Refer to PRECAUTION [10/2014 - ] .
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG) and turn the Techstream on.
- Wait 16 seconds or more.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Check for DTCs.RESULT
Display (DTC Output) Proceed to No output A P060B B P060B and P0327, P0328, P032C, P032D, P0332, P0333, P033C or P033D C
B → See step 3
C → See step 4
A → See step 2
- CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS [10/2014 - ]
- REPLACE ECM. Refer to REMOVAL [10/2014 - ]
- GO TO DTC (P0327, P0328, P032C, P032D, P0332, P0333, P033C and P033D). Refer to DTC P0327: Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor); DTC P0328: Knock Sensor 1 Circuit High Input (Bank 1 or Single Sensor); DTC P032C: Knock Sensor 3 Circuit Low; DTC P032D: Knock Sensor 3 Circuit High; DTC P0332: Knock Sensor 2 Circuit Low Input (Bank 2); DTC P0333: Knock Sensor 2 Circuit High Input (Bank 2); DTC P033C: Knock Sensor 4 Circuit Low Input; DTC P033D: Knock Sensor 4 Circuit High Input [10/2014 - ]