Test Mode Procedure [10/2014 - ]

DESCRIPTION

HINT:

When using a chassis dynamometer, brake tester, etc. to perform a vehicle test, activate test mode to avoid a "different tire diameter installed" incorrect judgment. Test mode does not have an AWD parameter. Test mode is activated because it will prohibit a different tire diameter judgment.

Control Status	AWD Control Status
During test mode	Different tire diameter malfunction judgment (detection that tire diameter of all wheels are not same) is not performed. Other than above item, normal control is performed.

ACTIVATE TEST MODE
HINT:

Activate test mode before using a chassis dynamometer, brake tester, etc. to perform a vehicle test.
1. Check that the engine switch is off.
2. Use either of the following methods to change the 4WD ECU assembly to test mode.
  1. Test mode activation by shorting the TS terminal
    - With the engine switch off, connect the TS and CG terminals of the DLC3 connector. Then turn the engine switch on (IG) to activate test mode.
    NOTE:
    If a part of the dynamic torque control AWD system has a defect, the AWD warning message is displayed on the multi-information display.
3. Check if the display of the multi-information display has changed to the AWD test mode display.
4. Start the engine.