Installation [08/2014 - ]: Procedure

INSTALL YAW RATE AND ACCELERATION SENSOR
1. Connect the yaw rate and acceleration sensor connector.
  NOTE:
  Make sure that the yaw rate and acceleration sensor connector is connected securely.
2. Install the yaw rate and acceleration sensor with the 2 bolts.
  Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf)
  NOTE:
  - Do not damage the yaw rate and acceleration sensor.
  - Make sure that the yaw rate and acceleration sensor is installed securely.
  - Do not use dropped or damaged parts.
  - Keep the contact surfaces of the yaw rate and acceleration sensor and the body free of foreign matter.
  - Make sure that the sensor is facing the correct direction.
INSTALL CONSOLE BOX LH
Refer to PROCEDURE - Step 13
INSTALL CONSOLE BOX INSERT
Refer to PROCEDURE - Step 14
INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY
Refer to PROCEDURE - Step 17
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
Refer to PROCEDURE - Step 18
INSTALL REAR CONSOLE BOX ASSEMBLY
(See article. Refer to INSTALLATION [08/2014 - ] )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
(See article. Refer to PROCEDURE - Step 3 )
PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION
(See article. Refer to CALIBRATION [08/2014 - ] )