April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation [07/2015 - ]: Procedure

INSTALL NO. 1 ECM BRACKET
1. Install the No. 1 ECM bracket with the nut.
  Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf)
2. Connect the 2 wire harness clamps.
3. Install the nut.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)

INSTALL ECM

Install the No. 2 ECM bracket to the ECM with the 2 screws.
Torque: 3.0 N*m (31 kgf*cm, 27 in.*lbf)

Temporarily install the screw (B).

GTY670548

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Install the ECM with the nut.
Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf)
Install the screw (A).
Torque: 3.0 N*m (31 kgf*cm, 27 in.*lbf)
Tighten the screw (B).
Torque: 3.0 N*m (31 kgf*cm, 27 in.*lbf)
Connect the 2 ECM connectors and lower the 2 levers.
NOTE:
- When connecting the connectors, make sure that dirt, water or other foreign matter does not become stuck between the connectors and other part.
- Make sure that the 2 levers are securely locked.

INSTALL BATTERY
Refer to PROCEDURE - Step 55
INSTALL COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 3
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [07/2015 - ] ).
PERFORM INITIALIZATION
Refer to PRECAUTION [07/2015 - ] ).