DTC P060B: Internal Control Module A/D Processing Performance [07/2015 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs (Refer to DTC CHECK / CLEAR [07/2015 - ] ).
5. Turn the Techstream off.
6. Turn the engine switch off.
7. Disconnect the Techstream.
8. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
9. Connect the cable to the negative (-) battery terminal.
10. Connect the Techstream to the DLC3.
11. Turn the engine switch on (IG).
12. Turn the Techstream on.
13. Wait for 16 seconds or more.
14. Enter the following menus: Powertrain / Engine / Trouble Codes.
15. Read the DTCs.
    RESULT
    
    

    Result	Proceed to
    DTC is not output	A
    DTC P060B is output	B
    DTC P060B and P0327, P0328, P0332 or P0333 are output	C

Result:  A

A 

CHECK FOR INTERMITTENT PROBLEMS 

(Refer to CHECK FOR INTERMITTENT PROBLEMS [07/2015 - ] )

Result:  B

B 

REPLACE ECM 

(Refer to REMOVAL [07/2015 - ] )

Result:  C

C 

GO TO DTC (P0327, P0328, P0332 AND P0333) 

(Refer to DTC P0327: Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor); DTC P0328: Knock Sensor 1 Circuit High Input (Bank 1 or Single Sensor); DTC P0332: Knock Sensor 2 Circuit Low Input (Bank 2); DTC P0333: Knock Sensor 2 Circuit High Input (Bank 2) [07/2015 - ] )