How To Proceed With Troubleshooting [09/2014 - 10/2015]: Procedure

Result

Result: 

NEXT 

See step  2

Result

Result: 

NEXT 

See step  3

Standard Voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

Result

Result: 

NG 

CHARGE OR REPLACE BATTERY 

Result: 

OK 

See step  4

1. Adjust the reflector height (Refer to ADJUSTMENT [09/2014 - 10/2015] ).
2. Place the reflector (Refer to ADJUSTMENT [09/2014 - 10/2015] ).
3. Connect the Techstream to the DLC3.
4. Turn the Techstream on.
5. Turn the cruise control switch (ON/OFF button) on.
6. Enter the following menus: Powertrain / Radar Cruise / Utility / Beam Axis Misalignment Reading.
7. Check the amount of misalignment and make a note.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  5

1. Using the Techstream, check if the CAN communication system is functioning normally.

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2014 - 10/2015] )

Result: 

A 

See step  6

1. Clear the DTCs (Refer to DTC CHECK / CLEAR [09/2014 - 10/2015] ).
2. Recheck for DTCs (Refer to DTC CHECK / CLEAR [09/2014 - 10/2015] ).

   Result

   Result	Proceed to
   DTCs are not output (symptoms can be confirmed or reproduced)	A
   DTCs are not output (symptoms cannot be confirmed or reproduced)	B
   DTCs are output	C

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2014 - 10/2015] )

Result: 

C 

See step  8

Result: 

A 

See step  7

1. Refer to problem symptoms table (Refer to PROBLEM SYMPTOMS TABLE [09/2014 - 10/2015] ).

   Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

Result: 

B 

ADJUST, REPAIR OR IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE 

Result: 

A 

See step  8

1. Terminals of ECU (Refer to TERMINALS OF ECU [09/2014 - 10/2015] )
2. Data List / Active Test (Refer to DATA LIST / ACTIVE TEST [09/2014 - 10/2015] )

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  9

HINT: 

Perform proper procedures according to corresponding faults listed in the problem symptoms table or the corresponding DTCs listed in the diagnostic trouble code chart.

Result

Result: 

NEXT 

See step  10

Result

Result: 

NEXT 

END