LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2016 >> IS 300 Base >> Repair and Diagnosis >> Steering >> Steering Control Systems >> Suspension Control System - Service Information >> Rear Acceleration Sensor >> Removal [08/2015 - 09/2020] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal [08/2015 - 09/2020]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [08/2015 - 10/2016] , or refer to PRECAUTION [10/2016 - 10/2017] , or refer to PRECAUTION [10/2017 - 09/2020]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [08/2015 - 10/2016] , or refer to INITIALIZATION [10/2016 - 10/2017] , or refer to INITIALIZATION [10/2017 - 09/2020]

  3. REMOVE LUGGAGE COMPARTMENT FLOOR MAT 

    Refer to PROCEDURE - Step 4

  4. REMOVE SPARE WHEEL COVER TRAY LH 

    Refer to PROCEDURE - Step 5

  5. REMOVE SPARE WHEEL COVER TRAY RH 

    Refer to PROCEDURE - Step 6

  6. REMOVE DECK SIDE TRIM BOX LH 

    Refer to PROCEDURE - Step 7

  7. REMOVE DECK SIDE TRIM BOX RH 

    Refer to PROCEDURE - Step 8

  8. REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER 

    Refer to PROCEDURE - Step 9

  9. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER 

    Refer to PROCEDURE - Step 10

  10. SEPARATE LUGGAGE COMPARTMENT TRIM COVER RH 
    1. Disengage the 2 claws and open the cover.
      GTY465289Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and rope hook assembly.
      GTY465292Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 4 clips.
      GTY968676Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Separate the luggage compartment trim cover RH from the body.
  11. REMOVE ACCELERATION SENSOR ASSEMBLY 
    1. Turn back the luggage compartment trim cover RH until the acceleration sensor assembly can be seen.
    2. Disconnect the connector.
      GTY468916Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the bolt and acceleration sensor assembly.
      NOTE:
      • Avoid any impact to the acceleration sensor assembly.
      • Do not drop the acceleration sensor assembly. If it is dropped, replace it with a new one.
scientia non olet · About LEMON Manuals