Installation [09/2016 - ]: Procedure

1. Install the sensor with the bolt.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

   NOTE:

   • The rear speed sensor is easily damaged. When installing the rear speed sensor to the rear axle hub RH, do not use excessive force to rotate and install it.
   • Prevent foreign matter from attaching to the sensor tip.
   • Do not drop the sensor. If the sensor has been dropped, replace the sensor with a new one.

1. Connect the connector to the rear speed sensor.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Install the sensor clamp with the bolt.

   Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

   NOTE:

   Do not twist the sensor wire when installing the clamps.

3. Connect the pad wear indicator connector.
4. Install the sensor clamp with the nut.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf) 

   NOTE:

   Do not twist the sensor wire when installing the clamps.

5. Except for coil spring type suspension:
   1. Install the sensor clamp (labeled A) with the nut (labeled B).

      Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf) 

   2. Connect the rear height control sensor connector (labeled C).
6. Insert the connector and grommet to the inside of the vehicle through the hole in the wheel house.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

7. for RH:
   1. Connect the rear speed sensor wire connector.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

8. for LH:
   1. Install the No. 1 skid control sensor clamp with the nut.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

   2. Attach the skid control sensor wire.
   3. Connect the sensor connector.

Torque: 140 N*m (1428 kgf*cm, 103 ft.*lbf) 

(Refer to PROCEDURE - Step 4 )

(Refer to INSTALLATION [09/2015 - ] )

Refer to PROCEDURE - Step 17

(Refer to TEST MODE PROCEDURE [09/2015 - ] )