DTC P060A: Internal Control Module Monitoring Processor Performance [09/2015 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear DTCs (Refer to DTC CHECK / CLEAR [09/2015 - ] ).
5. Turn the engine switch off and turn the Techstream off.
6. Disconnect the Techstream.
7. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute (Refer to PRECAUTION [09/2015 - ] ).
8. Connect the cable to the negative (-) battery terminal (Refer to PRECAUTION [09/2015 - ] ).
9. Connect the Techstream to the DLC3.
10. Turn the engine switch on (IG).
11. Turn the Techstream on.
12. Wait 16 seconds or more.
13. Enter the following menus: Powertrain / Engine / Trouble Codes.
14. Read the DTCs.

    Result

    Result	Proceed to
    No output	A
    P060A	B

Result:  A

A 

CHECK FOR INTERMITTENT PROBLEMS 

(Refer to CHECK FOR INTERMITTENT PROBLEMS [09/2015 - ] )

Result:  B

B 

REPLACE ECM 

(Refer to REMOVAL [09/2015 - ] )