Removal [09/2015 - ]: Procedure

REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
Refer to PROCEDURE - Step 3
REMOVE BATTERY SERVICE HOLE COVER LH
Refer to PROCEDURE - Step 4
PRECAUTION
NOTE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Refer to PRECAUTION [09/2015 - ] ).
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - ] ).
REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 10
REMOVE ENGINE ROOM SIDE COVER LH
Refer to PROCEDURE - Step 9
REMOVE ENGINE ROOM ECU COVER

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
NOTE:
- Wipe off any water on or around the ECU cover.
- Perform these procedures in a dry place away from rain, etc.
- Do not allow water to enter the ECM through its connectors areas, screw areas, etc.
1. Remove the 3 bolts and engine room ECU cover.
REMOVE HYBRID VEHICLE CONTROL ECU

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Disconnect the 4 hybrid vehicle control ECU connectors.
2. Remove the 2 nuts and hybrid vehicle control ECU.

DISCONNECT NO. 2 CONNECTOR HOLDER

Disconnect the 2 engine wire connectors.