Removal [09/2015 - ]: Procedure

1. Disable the Autoaway/Return function by changing the customize parameter (Refer to CUSTOMIZE PARAMETERS [09/2015 - ] ).
   NOTE:

   Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.

   HINT: 

   Performing the above operation causes the Autoaway/Return function to be disabled when the power switch is turned off.

2. Turn the power switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column.
3. Turn the power switch off.

Refer to PROCEDURE - Step 7

Refer to PROCEDURE - Step 8

Refer to PROCEDURE - Step 9

1. for Lower Side:
   1. Remove the 3 screws.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   2. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Detach the 2 claws to remove the steering column cover.

2. for Upper Side:

   1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Detach the 4 clips to remove the instrument cluster finish panel sub-assembly.

   2. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Disconnect the driver monitor camera connector.

   3. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Detach the claw to remove the steering column cover.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Detach the claw to disconnect the driver monitor camera connector.

2. Remove the screw.
3. Detach the guide to remove the driver monitor bracket.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Remove the 2 screws.

2. Detach the 2 claws to remove the driver monitor camera.