LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2016 >> LS 600h >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Pre-Collision System - Service Information >> Driver Monitor Ecu >> Removal [09/2015 - ] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal [09/2015 - ]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work (Refer to PRECAUTION [09/2015 - ] ).

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 3

  3. REMOVE BATTERY SERVICE HOLE COVER LH 

    Refer to PROCEDURE - Step 4

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - ] ).

  5. REMOVE INSTRUMENT SIDE PANEL LH 

    Refer to PROCEDURE - Step 7

  6. REMOVE INSTRUMENT PANEL ORNAMENT 

    Refer to PROCEDURE - Step 8

  7. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 10

  8. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 9

  9. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY 

    Refer to PROCEDURE - Step 10

  10. REMOVE DRIVER MONITOR ECU ASSEMBLY 
    1. GTY414718Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Disconnect the 3 connectors.

    2. Remove the 2 nuts and ECU unit.
    3. GTY414717Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Remove the nut and driver monitor ECU assembly.

scientia non olet · About LEMON Manuals