Inspection [08/2016 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2024 Lexus RC F, 2023 Lexus RC F, 2022 Lexus RC F, 2021 Lexus RC F, and 2020 Lexus RC F. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT FRONT ACCELERATION SENSOR LH

Connect 3 1.5 V dry cell batteries in series.
Connect a positive (+) lead from the batteries to terminal 3 (SGB) and a negative (-) lead to terminal 2 (SGG).

Measure the voltage according to the value(s) in the table below.

Standard Voltage

Tester Connection	Condition	Specified Condition
1 (SGFL) - 2 (SGG)	Sensor stationary	Approx. 2.3 V
1 (SGFL) - 2 (SGG)	Sensor vibrating vertically	Changes between approx. 0.9 and 3.6 V

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Component without harness connected (Front Acceleration Sensor LH)
	Top
	Bottom

NOTE:

Do not apply a voltage of more than 6 V.
Do not drop the front acceleration sensor. If it is dropped, replace it with a new one.
Never place the front acceleration sensor upside down.

HINT:

When the acceleration sensor is tilted, it may output a different value.