LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2016 >> RC F >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Registration >> Register Transmitter ID
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Register Transmitter ID

NOTE: The transmitter ID is written on the tire pressure warning valve and transmitter. It is not possible to read the transmitter ID after installing the tire onto the wheel. Therefore, make a note of the transmitter ID before installing the tire.
NOTE: If the ID registration step is not completed within 300 seconds, ID registration will be canceled.
  1. Set the tire pressure of all wheels (including spare tire) to pressure specified on the tire and loading information label.
  2. With ignition OFF, connect the Techstream to DLC3.
  3. Turn ignition switch to ON position. Turn Techstream ON.
  4. Enter the following menus: Chassis / Tire Pressure Monitor / Utility / ID Registration.
  5. Perform the procedures displayed on the Techstream.
    NOTE: If registration is not completed within 300 seconds, ID registration is canceled.
NOTE: After all IDs are registered, DTC C2126/26 is stored in the tire pressure warning ECU and the tire pressure warning light blinks for 1 minute and then comes on. When the tire pressure warning ECU successfully receives radio waves from all the transmitters whose IDs are stored in the ECU, DTC C2126/26 is cleared and the tire pressure warning light goes off.
scientia non olet · About LEMON Manuals