Installation [08/2014 - ]: Procedure
- INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
- Install the rear axle hub and bearing assembly (See article. Refer to PROCEDURE - Step 1
).
HINT:
- The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor malfunctions, replace the rear axle hub and bearing assembly.
- If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.
- Install the rear axle hub and bearing assembly (See article. Refer to PROCEDURE - Step 1
).
- CONNECT REAR SPEED SENSOR WIRE
- Connect the rear speed sensor wire connector to the rear speed sensor.
- INSPECT REAR AXLE HUB BEARING LOOSENESS
Refer to PROCEDURE - Step 13
- INSPECT REAR AXLE HUB RUNOUT
Refer to PROCEDURE - Step 14
- INSTALL REAR DISC
Refer to PROCEDURE - Step 1
- INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
Refer to PROCEDURE - Step 16
- CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
Refer to PROCEDURE - Step 10
- INSTALL PARKING BRAKE LEVER PROTECTOR
Refer to PROCEDURE - Step 3
- INSTALL REAR SUSPENSION ARM COVER
Refer to PROCEDURE - Step 12
- ADJUST PARKING BRAKE
(See article. Refer to ADJUSTMENT [08/2014 - ] )
- INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 14
- INSTALL INSTRUMENT SIDE PANEL LH
Refer to PROCEDURE - Step 15
- INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Refer to PROCEDURE - Step 41
- INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 28
- INSTALL REAR WHEEL
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- Connect the cable to the negative (-) battery terminal (See article. Refer to PROCEDURE - Step 3 ).
- Connect the reservoir level switch connector.
- Clear the DTCs (See article. Refer to DTC CHECK / CLEAR [08/2014 - ] ).
- CHECK FOR SPEED SENSOR SIGNAL
(See article. Refer to TEST MODE PROCEDURE [08/2014 - ] )