Installation [07/2015 - ]: Procedure
- INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
- Install the rear axle hub and bearing assembly (Refer to PROCEDURE - Step 1
).
HINT:
- The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.
- If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.
- Install the rear axle hub and bearing assembly (Refer to PROCEDURE - Step 1
).
- INSPECT REAR AXLE HUB BEARING LOOSENESS
Refer to PROCEDURE - Step 7
- INSPECT REAR AXLE HUB RUNOUT
Refer to PROCEDURE - Step 8
- CONNECT SKID CONTROL SENSOR WIRE
- Connect the connector to the rear speed sensor.
- INSTALL REAR DISC
Refer to PROCEDURE - Step 1
- INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG
Refer to PROCEDURE - Step 2
- INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
Refer to PROCEDURE - Step 11
- CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
- Connect the cable to the negative (-) auxiliary battery terminal (Refer to PROCEDURE - Step 2 ).
- Connect the reservoir level switch connector.
- Clear the DTCs (Refer to DTC CHECK / CLEAR [07/2015 - ] ).
- ADJUST PARKING BRAKE
Refer to ADJUSTMENT [07/2015 - ]
- INSTALL REAR WHEEL
Torque: 103 N*m (1049 kgf*cm, 76 ft.*lbf)
- CHECK FOR SPEED SENSOR SIGNAL
(Refer to TEST MODE PROCEDURE [07/2015 - ]