Installation [07/2015 - ]: Procedure
- INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
- Install the rear axle hub and bearing assembly (Refer to PROCEDURE - Step 1
).
HINT:
- The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.
- If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.
- Install the rear axle hub and bearing assembly (Refer to PROCEDURE - Step 1
).
- INSPECT REAR AXLE HUB BEARING LOOSENESS
Refer to PROCEDURE - Step 5
- INSPECT REAR AXLE HUB RUNOUT
Refer to PROCEDURE - Step 6
- CONNECT SKID CONTROL SENSOR WIRE
- Connect the connector to the rear speed sensor.
- INSTALL REAR DISC
Refer to PROCEDURE - Step 1
- INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG
Refer to PROCEDURE - Step 2
- INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
Refer to PROCEDURE - Step 9
- ADJUST PARKING BRAKE
(Refer to ADJUSTMENT [07/2015 - ] )
- INSTALL REAR WHEEL
Torque: 103 N*m (1049 kgf*cm, 76 ft.*lbf)
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [07/2015 - ] ).
- CHECK FOR SPEED SENSOR SIGNAL
(Refer to TEST MODE PROCEDURE [07/2015 - ] )