DTC P060A: Internal Control Module Monitoring Processor Performance [09/2014 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs (See servic information).Refer to DTC CHECK / CLEAR [09/2014 - ] ).
5. Turn the power switch off.
6. Turn the Techstream off.
7. Disconnect the Techstream.
8. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.
9. Connect the cable to the negative (-) auxiliary battery terminal.
10. Connect the Techstream to the DLC3.
11. Turn the power switch on (IG).
12. Turn the Techstream on.
13. Wait 16 seconds or more.
14. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
15. Read the DTCs.

    Result

    Result	Proceed to
    DTC is not output	A
    DTC P060A is output	B

Result:  A

A 

CHECK FOR INTERMITTENT PROBLEMS 

(See servic information).Refer to CHECK FOR INTERMITTENT PROBLEMS [09/2014 - ] )

Result:  B

B 

REPLACE ECM 

(See servic information).Refer to REMOVAL [09/2014 - ] )