Auto Down Operation does not Fully Open Power Window (Catch Protection Function is Activated) [10/2015 - ]: Procedure

1. Initialize the power window regulator motor assembly (applicable location).

   Refer to INITIALIZATION [10/2015 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Remove the window regulator.
2. Install the window glass to the door glass run.
3. Check if the door window regulator operates smoothly.
4. Check that the window glass slides smoothly when sliding it up by hand.
   NOTE:

   Perform initialization again.

   HINT: 

   Ensure the following: 

   • The window glass fits with the glass run without improper contact or deformation.
   • Foreign matter is not caught in the glass run.
   • The glass run is not misaligned.
   • The belt moulding or inner weatherstrip is not caught.
   • The glass is not tilted and does not catch.

   OK

   Door window glass slides smoothly.

   Result

   Result	Proceed to
   OK (Driver door power window)	A
   OK (Front passenger door power window)
   OK (Rear LH door power window)	B
   OK (Rear RH door power window)
   NG	C

Result: 

A 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER DOOR OR FRONT PASSENGER DOOR). Refer to  REMOVAL [10/2015 - 09/2017]  , or refer to  REMOVAL [09/2017 - ] 

Result: 

B 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR LH DOOR OR REAR RH DOOR). Refer to  REMOVAL [10/2015 - 09/2017]  , or refer to  REMOVAL [09/2017 - ] 

Result: 

C 

FIT WINDOW GLASS CORRECTLY (REMOVE FOREIGN MATTER CAUSING IMPROPER FIT OR REPLACE PARTS)