Installation [10/2015 - ]: Procedure

INSTALL NO. 1 CONSOLE BOX MOUNTING BRACKET
1. Engage the 2 hooks to install the No. 1 console box mounting bracket.
2. Install the 3 bolts.
  Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf)
3. Engage the 3 clamps to install the wire harness to the No. 1 console box mounting bracket.
INSTALL YAW RATE AND ACCELERATION SENSOR (YAW RATE SENSOR)
1. Install the yaw rate and acceleration sensor (yaw rate sensor) with the 2 nuts.
  Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf)
  NOTE:
  - Do not drop the yaw rate and acceleration sensor (yaw rate sensor).
  - If the yaw rate and acceleration sensor (yaw rate sensor) is dropped, replace it with a new one.
2. Connect the connector to the yaw rate and acceleration sensor (yaw rate sensor).
  NOTE:
  Make sure that the yaw rate and acceleration sensor (yaw rate sensor) connector is connected securely.
3. Install the No. 1 console box duct to the No. 1 console box mounting bracket with the 2 clips.
INSTALL NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY
Refer to INSTALLATION [10/2015 - ]
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 2

NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [10/2015 - 09/2016] , or Refer to INITIALIZATION [09/2016 - 09/2017] , or Refer to INITIALIZATION [09/2017 - ]
PERFORM YAW RATE AND ACCELERATION SENSOR AND ROLL RATE AND VERTICAL ACCELERATION SENSOR ZERO POINT CALIBRATION
Refer to CALIBRATION [10/2015 - 09/2017] , or Refer to CALIBRATION [09/2017 - ]