Installation [10/2015 - ]: Procedure

INSTALL SPARK PLUG
HINT:

Perform "Inspection After Repair" after replacing a spark plug.

Refer to INITIALIZATION [10/2015 - ]
1. Install the 8 spark plugs to the cylinder head sub-assembly and cylinder head LH.
  Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
  
  NOTE:
  If a spark plug has been struck or dropped, replace it.
  
  HINT:
  
  Install the same parts to their original positions.
INSTALL IGNITION COIL ASSEMBLY
Refer to PROCEDURE - Step 2
INSTALL NO. 3 ENGINE ROOM RELAY BLOCK ASSEMBLY
Refer to PROCEDURE - Step 4
INSTALL NO. 1 ENGINE ROOM RELAY BLOCK ASSEMBLY
Refer to PROCEDURE - Step 5
INSTALL BATTERY TRAY
Refer to PROCEDURE - Step 6
INSTALL POWER STEERING ECU ASSEMBLY
Refer to INSTALLATION [10/2015 - ]
INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 2 [10/2015 - 09/2017] or refer to PROCEDURE - Step 2 [09/2017 - 05/2018] or refer to PROCEDURE - Step 2 [05/2018 - ]
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
See step 2

NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [10/2015 - 09/2016] or refer to INITIALIZATION [09/2016 - 09/2017] or refer to INITIALIZATION [09/2017 - ]
PERFORM INITIALIZATION
1. Perform "Inspection After Repair" after replacing an ignition coil assembly and spark plug.
  Refer to INITIALIZATION [10/2015 - ]