Removal [08/2015 - 08/2019]: Procedure
- PRECAUTION NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Refer to PRECAUTION [08/2015 - ] ).
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL WARNING:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2015 - 08/2019] ).
- REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 1
- REMOVE INSTRUMENT PANEL FINISH PANEL END LH
Refer to PROCEDURE - Step 5
- REMOVE DOOR SCUFF PLATE ASSEMBLY LH
Refer to PROCEDURE - Step 5 [08/2015 - 08/2016] , or refer to PROCEDURE - Step 5 [08/2016 - 08/2019]
- REMOVE COWL SIDE TRIM BOARD LH
Refer to PROCEDURE - Step 7 [08/2015 - 08/2016] , or refer to PROCEDURE - Step 7 [08/2016 - 08/2019]
- REMOVE INSTRUMENT SIDE PANEL LH
Refer to PROCEDURE - Step 17
- REMOVE NO. 2 SWITCH HOLE BASE
Refer to PROCEDURE - Step 18
- REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION
Refer to PROCEDURE - Step 19
- REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
Refer to PROCEDURE - Step 20
- REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 24
- REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to PROCEDURE - Step 7
- REMOVE DRIVER MONITOR ECU ASSEMBLY