Removal [04/2013 - 08/2015]: Procedure

PRECAUTION
NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Refer to PRECAUTION [04/2013 - 08/2015]
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [04/2013 - 06/2014] , or refer to INITIALIZATION [06/2014 - 08/2015]
REMOVE LUGGAGE COMPARTMENT FLOOR MAT
Refer to PROCEDURE - Step 4
REMOVE SPARE WHEEL COVER TRAY LH
Refer to PROCEDURE - Step 5
REMOVE SPARE WHEEL COVER TRAY RH
Refer to PROCEDURE - Step 6
REMOVE DECK SIDE TRIM BOX LH
Refer to PROCEDURE - Step 7
REMOVE DECK SIDE TRIM BOX RH
Refer to PROCEDURE - Step 8
REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER
Refer to PROCEDURE - Step 9
REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (for Fixed Seat Type)
Refer to PROCEDURE - Step 10
REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (for Fold Down Seat Type)
Refer to PROCEDURE - Step 11

SEPARATE LUGGAGE COMPARTMENT TRIM COVER

Disengage the 2 claws and open the cover.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the bolt and rope hook assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the 4 clips.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

for LH Side:
1. Remove the clip (A).
Separate the luggage compartment trim cover from the body.

REMOVE REAR WHEEL

SEPARATE REAR WHEEL HOUSE LINER

Remove the 2 nuts and separate the rear wheel house liner.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE REAR SPEED SENSOR

Turn back the luggage compartment trim cover until the rear speed sensor connector can be seen.

Disengage the rear speed sensor connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

for LH Side

for RH Side

Remove the 3 bolts and separate the rear speed sensor and 2 sensor clamps from the rear axle carrier sub-assembly and rear upper control arm assembly.

NOTE:

Prevent foreign matter from attaching to the rear speed sensor tip.
Clean the speed sensor installation hole and the contact surfaces every time the rear speed sensor is removed.

Turn back the rear wheel house liner until the grommet can be disengaged.

Remove the 2 nuts and 2 sensor clamps.

Disengage the grommet and remove the rear speed sensor.