Installation [09/2020 - ]: Procedure

1. Install the rear speed sensor to the rear axle carrier sub-assembly with the bolt.

   Torque: 8.5 N.m (87 kgf/cm, 75 in.lbf) 

   NOTE:

   • Keep the tip of the rear speed sensor and installation hole free of foreign matter.
   • Firmly insert the rear speed sensor body into the rear axle carrier sub-assembly before tightening the bolt.
   • After installing the rear speed sensor to the rear axle carrier sub-assembly, make sure that there is no clearance between the rear speed sensor stay and rear axle carrier sub-assembly. Also make sure that no foreign matter is stuck between the parts.
2. Connect the rear speed sensor connector to the parking brake wire assembly.
   NOTE:

   Do not twist the rear speed sensor wire harness when installing it.

Refer to PROCEDURE - Step 1 [09/2020 - 10/2023] , or refer to PROCEDURE - Step 2 [10/2023 - ]

Refer to TEST MODE PROCEDURE [09/2020 - 11/2021] , or refer to TEST MODE PROCEDURE [11/2021 - ]