On-Vehicle Inspection [04/2013 - 10/2017]: Procedure
- INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.
Powertrain > Engine > Data List
Tester Display Accel Sensor Out No. 1 Accel Sensor Out No. 2 - Read the values displayed on the Techstream.
Standard Voltage
Accelerator Pedal Operation Accel Sensor Out No. 1 Accel Sensor Out No. 2 Fully released 0.5 to 1.1 V 1.2 to 2.0 V Fully depressed 2.6 to 4.5 V 3.4 to 4.75 V If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.