General Maintenance [08/2015 - 10/2017]: Procedure

INSPECT STEERING LINKAGE AND GEAR HOUSING
1. Check the steering wheel free play.
  Refer to ON-VEHICLE INSPECTION [04/2013 - ]
2. Check the steering linkage for looseness or damage.
  1. Check that the tie rod ends do not have any play.
  2. Check that the dust seals and boots are not damaged.
  3. Check that the boot clamps are not loose.
  4. Check that the steering gear housing is not damaged.
INSPECT BALL JOINTS AND DUST COVERS
1. Inspect the ball joints for excessive looseness.
  1. Jack up the front of the vehicle and place wooden blocks with a height of 180 to 200 mm (7.09 to 7.87 in.) under the front tires.
  2. Lower the vehicle until the front coil spring has about half its ordinary load. Place stands under the vehicle for safety.
  3. Check that the front wheels are pointing straight ahead. Use wheel chocks on all 4 wheels.
  4. Using a lever, pry up the end of the lower arm. Check the amount of play.
    Maximum ball joint vertical play
    
    0 mm (0 in.)
    
    If there is any play, replace the ball joint.
2. Check the dust cover for damage.
INSPECT DRIVE SHAFT BOOTS
1. Check the drive shaft boots for loose clamps, cracks, grease leaks, kinks or damage.
INSPECT AUTOMATIC TRANSMISSION
1. Visually check the transmission for fluid leaks. If fluid is leaking, find the cause and repair it.
INSPECT AUTOMATIC TRANSMISSION FLUID COOLER HOSE AND CONNECTIONS
1. Check the automatic transmission fluid cooler hoses (oil cooler hoses) for cracks, leakage, loose connections and deformation.
INSPECT TRANSFER (for AWD)
1. Visually check the transfer for oil leaks. If oil is leaking, find the cause and repair it.
INSPECT DIFFERENTIAL
1. Visually check the rear differential for fluid leaks. If oil is leaking, find the cause and repair it.
INSPECT FRONT AND REAR SUSPENSION
1. Check the front and rear suspension.
  For Front Suspension: Refer to ADJUSTMENT [08/2015 - 10/2016] , or refer to ADJUSTMENT [10/2016 - 09/2020]
  
  For Rear Suspension: Refer to ADJUSTMENT [08/2015 - 10/2016] , or refer to ADJUSTMENT [10/2016 - 09/2020]
TIGHTEN PROPELLER SHAFT BOLT
1. Tighten the propeller shaft bolts.
  For AWD (Front Propeller Shaft Assembly): Refer to INSTALLATION [08/2015 - ]
  
  For 2GR-FSE 2WD (Propeller Shaft Assembly): Refer to INSTALLATION [04/2013 - ]
  
  For 2GR-FSE AWD (Propeller Shaft Assembly): Refer to INSTALLATION [04/2013 - ]
  
  For 8AR-FTS (Propeller Shaft Assembly): Refer to INSTALLATION [08/2015 - ]