How To Proceed With Troubleshooting [09/2015 - ]: Procedure

Result

Result:  1

NEXT 

See step  2

Standard Voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result

Result:  1

NEXT 

See step  3

1. Using the Techstream, check the electric power control system's load control history.

   Refer to PROBLEM SYMPTOMS TABLE [09/2015 - ]

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  4

1. Use the Techstream to check that the CAN communication system is functioning normally.

   Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2015 - ]

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

Result:  2

B 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2015 - ] 

Result:  1

A 

See step  5

1. Refer to the problem symptoms table.

   Refer to PROBLEM SYMPTOMS TABLE [09/2015 - ] 

   Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

Result:  2

B 

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE 

Result:  1

A 

See step  6

1. Terminals of ECU

   Refer to TERMINALS OF ECU [09/2015 - ] 

2. DATA LIST / ACTIVE TEST

   Refer to DATA LIST / ACTIVE TEST [09/2015 - ] 

3. On-vehicle Inspection

   Refer to ON-VEHICLE INSPECTION [09/2015 - ]

4. Inspection

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  7

Result

Result:  1

NEXT 

See step  8

Result

Result:  1

NEXT 

END