How To Proceed With Troubleshooting [09/2015 - ]: Procedure

Result

Result:  1

NEXT 

See step  2

Standard voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result

Result:  1

NEXT 

See step  3

1. Using the Techstream, check if the CAN communication system is functioning normally.

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

Result:  2

B 

GO TO CAN COMMUNICATION SYSTEM 

Result:  1

A 

See step  4

1. Check the Data List's load control history (number of items) and the final load control history*. Then write down the information.

   HINT: 

   Refer to the following description for information about "final load control history".

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  5

1. Check for DTCs and write them down.
2. Delete the DTC.
3. Check for DTC again.

   Result

   Result	Proceed to
   No DTCs, symptom confirmation and symptom simulation can be performed	A
   No DTCs, symptom confirmation and symptom simulation cannot be performed	B
   DTC output	C

Result:  2

B 

GO TO INTRODUCTION. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2015 - ] 

Result:  3

C 

See step  8

Result:  1

A 

See step  6

Result

Result:  2

B 

See step  8

Result:  1

A 

See step  7

1. Data List / Active Test

   Refer to DATA LIST / ACTIVE TEST [09/2015 - ] 

2. Terminals of ECU

   Refer to TERMINALS OF ECU [09/2015 - ] 

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  8

Result

Result:  1

NEXT 

See step  9

Result

Result:  1

NEXT 

END