Removal [09/2015 - ]: Procedure

REMOVE COWL TOP VENTILATOR LOUVER RH

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Remove the 6 clips and cowl top ventilator louver RH.
PRECAUTION
NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Refer to PRECAUTION [09/2015 - ] ).
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - ] ).
REMOVE V-BANK COVER SUBASSEMBLY
Refer to PROCEDURE - Step 1
REMOVE AIR CLEANER INLET COVER SUBASSEMBLY
Refer to PROCEDURE - Step 2
REMOVE NO. 1 AIR CLEANER INLET
Refer to PROCEDURE - Step 3
REMOVE FRONT WHEEL OPENING EXTENSION PAD LH (for AWD)
Refer to PROCEDURE - Step 7
REMOVE FRONT WHEEL OPENING EXTENSION PAD RH (for AWD)
Refer to PROCEDURE - Step 8
REMOVE NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 6
REMOVE FRONT SUSPENSION MEMBER PROTECTOR LOWER (for 2WD)
Refer to PROCEDURE - Step 12
REMOVE FRONT SUSPENSION MEMBER PROTECTOR LOWER (for AWD)
Refer to PROCEDURE - Step 17
REMOVE NO. 2 ENGINE UNDER COVER (for 2WD)
Refer to PROCEDURE - Step 11
REMOVE NO. 2 ENGINE UNDER COVER (for AWD)
Refer to PROCEDURE - Step 13
REMOVE INTAKE AIR CONNECTOR PIPE
Refer to PROCEDURE - Step 9
REMOVE V-RIBBED BELT
Refer to PROCEDURE - Step 5

REMOVE GENERATOR ASSEMBLY

Remove the nut, and disconnect the harness from the +B terminal.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the 2 bolts and 2 nuts.

Using an E8 "TORX" socket wrench, remove the 2 stud bolts and generator.