How To Proceed With Troubleshooting [09/2015 - ]: Procedure

Result

Result:  1

NEXT 

See step  2

Standard Voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result

Result:  1

NEXT 

See step  3

1. Using the Techstream, check if the CAN communication system is functioning normally.

   Refer to DIAGNOSIS SYSTEM [09/2015 - ]

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

Result:  2

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART 

Result:  1

A 

See step  4

1. Check for DTCs and note any stored DTCs.

   Refer to DTC CHECK / CLEAR [09/2015 - ] 

2. Delete the DTCs.
3. Check whether the same DTC(s) relevant to the SFI system or smart access system with push-button start recurs by reproducing the symptoms indicated by the noted DTC(s) in the first step above.

   Result

   Result	Proceed to
   DTC output does not reoccur	A
   SFI system DTC output reoccurs	B
   Smart access system with push-button start DTC output reoccurs	C

Result:  2

B 

GO TO SFI SYSTEM 

Result:  3

C 

See step  7

Result:  1

A 

See step  5

Result

Result:  2

B 

See step  7

Result:  1

A 

See step  6

1. Terminals of ECU

   Refer to TERMINALS OF ECU [09/2015 - ] 

2. DATA LIST / ACTIVE TEST

   Refer to DATA LIST / ACTIVE TEST [09/2015 - ] 

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  7

Result

Result:  1

NEXT 

See step  8

Result

Result:  1

NEXT 

END