DTC P060B: Internal Control Module A/D Processing Performance [09/2015 - ]: Procedure

1. Clear DTCs (Refer to DTC CHECK / CLEAR [09/2015 - ] ).
2. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute (Refer to PRECAUTION [09/2015 - ] ).
3. Connect the cable to the negative (-) battery terminal (Refer to PRECAUTION [09/2015 - ] ).
4. Connect the Techstream to the DLC3.
5. Turn the engine switch on (IG) and turn the Techstream on.
6. Wait 16 seconds or more.
7. Enter the following menus: Powertrain / Engine / Trouble Codes.
8. Check for DTCs.
   RESULT
   
   

   Display (DTC Output)	Proceed to
   No output	A
   P060B	B
   P060B and P0327, P0328, P032C, P032D, P0332, P0333, P033C or P033D	C

Result:  A

A 

CHECK FOR INTERMITTENT PROBLEMS 

(Refer to CHECK FOR INTERMITTENT PROBLEMS [09/2015 - ] )

Result:  B

B 

REPLACE ECM 

(Refer to REMOVAL [09/2015 - ] )

Result:  C

C 

GO TO DTC (P0327, P0328, P032C, P032D, P0332, P0333, P033C and P033D) 

(Refer to DTC P0327: Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor); DTC P0328: Knock Sensor 1 Circuit High Input (Bank 1 or Single Sensor); DTC P032C: Knock Sensor 3 Circuit Low; DTC P032D: Knock Sensor 3 Circuit High; DTC P0332: Knock Sensor 2 Circuit Low Input (Bank 2); DTC P0333: Knock Sensor 2 Circuit High Input (Bank 2); DTC P033C: Knock Sensor 4 Circuit Low Input; DTC P033D: Knock Sensor 4 Circuit High Input [09/2015 - ] )