DTC U0319: Software Incompatible with Steering Effort Control Module or Internal Control Module EEPROM Error [09/2015 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG) and turn the Techstream on.
3. Enter the following menus: Powertrain / Engine / Trouble Codes.
4. Read the DTCs.
   RESULT
   
   

   Result	Proceed to
   Only DTC U0319 is output	A
   DTC U0319 and other DTCs are output	B

   HINT: 

   If any DTCs other than U0319 are output, troubleshoot those DTCs first.

Result:  B

B 

GO TO DTC CHART 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2015 - 09/2016] Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2016 - ] )

Result:  A

A 

See step  2

1. Perform Shift Control Synchronization (Refer to PROCEDURE - Step 2 ).

Result:  NEXT

NEXT 

See step  3

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG) and turn the Techstream on.
3. Clear the DTCs (Refer to DTC CHECK / CLEAR [09/2015 - ] ).
4. Turn the engine switch on (IG) and wait for 3 seconds.
5. Enter the following menus: Powertrain / Engine / Trouble Codes.
6. Read the DTCs.
   RESULT
   
   

   Result	Proceed to
   DTC is not output	A
   DTC U0319 is output	B

Result:  A

A 

END 

Result:  B

B 

REPLACE ECM 

(Refer to REMOVAL [09/2015 - ] )