General Maintenance [09/2015 - ]: Procedure
- INSPECT DRIVE BELT (for 2WD)
Refer to PROCEDURE - Step 1
- INSPECT DRIVE BELT (for AWD)
Refer to PROCEDURE - Step 1
- REPLACE ENGINE OIL AND OIL FILTER
- Replace engine oil and oil filter (for 2WD) (Refer to REPLACEMENT [09/2015 - ] ).
- Replace engine oil and oil filter (for AWD) (Refer to REPLACEMENT [09/2015 - ] ).
- INSPECT ENGINE COOLANT
- Inspect the engine coolant (Refer to ON-VEHICLE INSPECTION [09/2015 - ] ).
- REPLACE ENGINE COOLANT
- Replace the engine coolant (Refer to REPLACEMENT [09/2015 - ] ).
- INSPECT EXHAUST PIPES AND MOUNTINGS
- Visually check the pipes, hangers and connections for severe corrosion, leaks or damage.
- INSPECT BATTERY
Refer to PROCEDURE - Step 1
- INSPECT AIR CLEANER FILTER
- Remove the air cleaner filter.
- Visually check that the air cleaner filter is not excessively damaged or oily.
- Replace the air cleaner filter with a new one, if necessary.
- INSPECT FUEL LINES, FUEL LINE CONNECTIONS, FUEL TANK VAPOR VENT SYSTEM HOSES AND FUEL TANK BAND
- Visually check the fuel lines and hoses for cracks, leakage, loose connections and deformation. Also, visually check the tank band for looseness.
- INSPECT FUEL TANK CAP GASKET
Refer to PROCEDURE - Step 1
- REPLACE SPARK PLUGS
Refer to PROCEDURE - Step 3