Inspection [09/2014 - 11/2017]: Procedure
- INSPECT PRE-COLLISION SYSTEM CANCEL SWITCH ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Pre-collision System Cancel Switch Assembly)Standard Resistance
Tester Connection Condition Specified Condition 1 - 2 Pressed Below 50 Ω 1 - 2 Not pressed 1 MΩ or higher If the result is not as specified, replace the pre-collision system cancel switch assembly.
- Measure the resistance according to the value(s) in the table below.