DTC P062F: Internal Control Module EEPROM Error [07/2015 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs (Refer to DTC CHECK / CLEAR [07/2015 - ] ).
5. Turn the engine switch off and turn the Techstream off.
6. Disconnect the Techstream.
7. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
8. Connect the cable to the negative (-) battery terminal.
9. Connect the Techstream to the DLC3.
10. Turn the engine switch on (IG).
11. Turn the Techstream on.
12. Start the engine and wait 30 seconds or more.
13. Enter the following menus: Powertrain / Engine / Trouble Codes.
14. Read the DTCs.
    RESULT
    
    

    Result	Proceed to
    DTC is not output	A
    DTC P062F is output	B

Result:  A

A 

CHECK FOR INTERMITTENT PROBLEMS 

(Refer to CHECK FOR INTERMITTENT PROBLEMS [07/2015 - ] )

Result:  B

B 

REPLACE ECM 

(Refer to REMOVAL [07/2015 - ] )