LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2018 >> GS 300 Base >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Pre-Collision System - Service Information >> Driver Monitor Ecu >> Installation [09/2014 - 10/2015] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation [09/2014 - 10/2015]: Procedure

  1. INSTALL DRIVER MONITOR ECU ASSEMBLY 
    1. Install the driver monitor ECU assembly with the nut.

      Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

    2. Connect the connector.
  2. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY 

    Refer to PROCEDURE - Step 1

  3. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 26

  4. INSTALL INSTRUMENT PANEL FINISH PANEL END LH 

    Refer to PROCEDURE - Step 6

  5. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL 

    Refer to PROCEDURE - Step 8

  6. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 27

  7. INSTALL NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 28

  8. INSTALL INSTRUMENT SIDE PANEL LH 

    Refer to PROCEDURE - Step 29

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2014 - 10/2015] ).

  10. CHECK SRS WARNING LIGHT 

    (Refer to DIAGNOSIS SYSTEM [09/2014 - ] )

scientia non olet · About LEMON Manuals