How To Proceed With Troubleshooting [09/2014 - 10/2015]: Procedure

Result

Result:  1

NEXT 

See step  2

Result

Result:  1

NEXT 

See step  3

Standard Voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding.

Result

Result:  1

NEXT 

See step  4

1. Adjust the reflector height.

   Refer to ADJUSTMENT [09/2014 - 10/2015]

2. Place the reflector.

   Refer to ADJUSTMENT [09/2014 - 10/2015]

3. Connect the Techstream to the DLC3.
4. Turn the Techstream on.
5. Turn the cruise control switch (ON/OFF button) on.
6. Enter the following menus: Powertrain / Radar Cruise / Utility / Beam Axis Misalignment Reading.
7. Check the amount of misalignment and make a note.

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  5

1. Using the Techstream, check if the CAN communication system is functioning normally.

   Refer to DIAGNOSIS SYSTEM [09/2014 - 10/2015]

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

Result:  2

B 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2014 - 10/2015] 

Result:  1

A 

See step  6

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [09/2014 - 10/2015] 

2. Recheck for DTCs.

   Refer to DTC CHECK / CLEAR [09/2014 - 10/2015] 

   Result

   Result	Proceed to
   DTCs are not output (symptoms can be confirmed or reproduced)	A
   DTCs are not output (symptoms cannot be confirmed or reproduced)	B
   DTCs are output	C

Result:  2

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [09/2014 - 10/2015]  

Result:  3

C 

See step  8

Result:  1

A 

See step  7

1. Refer to problem symptoms table.

   PROBLEM SYMPTOMS TABLE [09/2014 - 10/2015] 

   Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

Result:  2

B 

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE 

Result:  1

A 

See step  8

1. Terminals of ECU.

   Refer to TERMINALS OF ECU [09/2014 - 10/2015] 

2. Data List / Active Test.

   Refer to DATA LIST / ACTIVE TEST [09/2014 - 10/2015] 

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  9

HINT: 

Perform proper procedures according to corresponding faults listed in the problem symptoms table or the corresponding DTCs listed in the diagnostic trouble code chart.

Result

Result:  1

NEXT 

See step  10

Result

Result:  1

NEXT 

END