Removal & Installation

WARNING: This page is about the GX 460 Base, which is a different variant/trim than selected.

Applies To	Note	Standard Hours	Skill Level
	Includes: Confirm Fluid temperature for level check.	10.7	C
Combination Procedure: CONVERTER: Drain & Test:
		0.2	C
Combination Procedure: CRANKSHAFT MAIN OIL SEAL: Remove & Replace:
Rear		0.4	B
Combination Procedure: FLYWHEEL: Remove & Replace:
		0.2	C
Combination Procedure: INPUT SHAFT SEAL: Remove & Replace:
		0.2	B
Combination Procedure: OIL PUMP: Remove & Replace:
		0.6	B
Combination Procedure: OIL PUMP SEAL: Remove & Replace:
		0.3	B
Combination Procedure: TORQUE CONVERTER: Remove & Replace:
		0.1	C
Combination Procedure: TRANSFER CASE ASSEMBLY: Overhaul:
	Includes: R&I Transfer Case Assembly.	6.3	A
Combination Procedure: TRANSFER CASE ASSEMBLY: Removal & Installation:
		0.5	C
Combination Procedure: TRANSFER CASE ASSEMBLY: Replace:
	Includes: R&I Transfer Case Assembly.	0.8	C
Combination Procedure: TRANSMISSION ASSEMBLY: Replace:
	Includes: Initialization. Includes: R&I Transfer Case Assembly.	1.1	C
Combination Procedure: TRANSMISSION OIL COOLER: Clean:
		0.5	C