DTC P062F-44: Internal Control Module EEPROM Data Memory Failure [12/2017 - 10/2020]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs.

   Powertrain > Engine > Clear DTCs 

5. Turn the engine switch off.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
2. Connect the cable to the negative (-) battery terminal.
3. Connect the Techstream to the DLC3.
4. Start the engine and wait 30 seconds or more.
5. Turn the Techstream on.
6. Enter the following menus: Powertrain / Engine / Trouble Codes.
7. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   DTC P062F-44 is output	B

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [12/2017 - ] 

Result: 

B 

REPLACE ECM. Refer to  REMOVAL [12/2017 - 09/2018]  , or refer to  REMOVAL [09/2018 - 10/2020]