Installation [03/2017 - ]: Procedure
- INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY
- Connect the No. 4 water by-pass hose and No. 5 water by-pass hose to the throttle body with motor assembly and slide the 2 clips to secure the hoses.
*1 No. 4 Water By-pass Hose *2 No. 5 Water By-pass Hose *a Paint Mark *b Down *c Front HINT:
Make sure the direction of the clip is as shown in the illustration.
- Temporarily install a new gasket and the throttle body with motor assembly to the intake air surge tank assembly with the 2 stud bolts.NOTE:
If the throttle body with motor assembly has been struck or dropped, replace it.
- Using an E6 "TORX" socket wrench, tighten the 2 stud bolts.
Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
- Install the gasket and throttle body with motor assembly with the 2 bolts and 2 nuts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
- Connect the No. 5 water by-pass hose to the water inlet housing and slide the clip to secure the hose.
- Connect the No. 4 water by-pass hose to the front water by-pass joint and slide the clip to secure the hose.
- Connect the throttle body with motor assembly connector.
- Connect the No. 4 water by-pass hose and No. 5 water by-pass hose to the throttle body with motor assembly and slide the 2 clips to secure the hoses.
- INSTALL AIR CLEANER HOSE ASSEMBLY
- Connect the air cleaner hose assembly to the throttle body with motor assembly.
- Tighten the 4 hose clamps.
Torque: 4.0 N*m (41 kgf*cm, 35 in.*lbf)
- CONNECT NO. 2 PCV HOSE
- Connect the No. 2 PCV hose the air cleaner hose assembly and slide the clip to secure the hose.
- CONNECT NO. 3 PCV HOSE
- Connect the No. 3 PCV hose to the air cleaner hose assembly and slide the clip to secure the hose.
- ADD ENGINE COOLANT
Refer to REPLACEMENT [03/2017 - 09/2023] , or refer to REPLACEMENT [09/2023 - ]
- INSPECT FOR COOLANT LEAK
Refer to PROCEDURE - Step 3
- INSTALL LOWER RADIATOR AIR DEFLECTOR
Refer to PROCEDURE - Step 8 [03/2017 - 05/2023] , or refer to PROCEDURE - Step 8 [05/2023 - ]
- INSTALL RADIATOR SUPPORT TO FRAME SEAL LH
Refer to PROCEDURE - Step 9 [03/2017 - 05/2023] , or refer to PROCEDURE - Step 9 [05/2023 - ]
- INSTALL RADIATOR SUPPORT TO FRAME SEAL RH
Refer to PROCEDURE - Step 10 [03/2017 - 05/2023] , or refer to PROCEDURE - Step 10 [05/2023 - ]
- INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 138 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 138 [06/2019 - 05/2023] , or refer to PROCEDURE - Step 141 [05/2023 - 09/2023] , or refer to PROCEDURE - Step 147 [09/2023 - ]