Installation [07/2022 - ]: Procedure

INSTALL ACCELERATION SENSOR ASSEMBLY LH (for Driver Side)
1. Install the acceleration sensor assembly LH with the 2 nuts.
  Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf)
  NOTE:
  - Avoid any impact to the acceleration sensor assembly LH.
  - Do not drop the acceleration sensor assembly LH. If it is dropped, replace it with a new one.
2. Connect the connector.
INSTALL ACCELERATION SENSOR ASSEMBLY RH (for Front Passenger Side)
HINT:

Perform the same procedure as for the LH side.
INSTALL INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY WITH MAIN BODY ECU (for Driver Side)
Refer to INSTALLATION [10/2018 - ]
INSTALL WINDSHIELD WIPER RELAY ASSEMBLY (for Front Passenger Side)
Refer to INSTALLATION [10/2018 - ]