LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2020 >> GS F >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System - Service Information >> Knock Sensor >> Removal [10/2015 - ] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal [10/2015 - ]: Procedure

  1. REMOVE INTAKE AIR SURGE TANK ASSEMBLY 

    Refer to REMOVAL [10/2015 - 09/2017] , or Refer to REMOVAL [09/2017 - ]

  2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 8 [10/2015 - 09/2017], or Refer to PROCEDURE - Step 8 [09/2017 - 05/2018], or Refer to PROCEDURE - Step 8 [05/2018 - ]

  3. REMOVE NO. 2 ENGINE COVER SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 2 [10/2015 - 09/2017], or Refer to PROCEDURE - Step 2 [09/2017 - ]

  4. REMOVE NO. 4 FUEL PIPE SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 3 [10/2015 - 09/2017], or Refer to PROCEDURE - Step 3 [09/2017 - ]

  5. REMOVE CASE SEPARATOR 
    1. Disconnect the fuel pressure sensor connector.
      GTY521513Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 4 bolts and case separator.
      GTY515751Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE KNOCK SENSOR 
    1. Disconnect the 4 knock sensor connectors.
      GTY517338Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a for Bank 2 Sensor 1
      *b for Bank 2 Sensor 2
      *c for Bank 1 Sensor 1
      *d for Bank 1 Sensor 2
      Engine Front
    2. Remove the 4 bolts and 4 knock sensors from the cylinder block sub-assembly.
      NOTE:

      If a knock sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals