Installation [03/2017 - ]: Procedure

HINT: 

Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.

Refer to INITIALIZATION [03/2017 - ]

1. for Bank 2:
   1. Install the mass air flow meter sub-assembly with the 2 screws.
      NOTE:

      • If the mass air flow meter sub-assembly has been struck or dropped, replace it.
      • If reusing the mass air flow meter sub-assembly, be sure to inspect the O-ring.
      • Make sure that the O-ring is not cracked or does not move out of place during installation.
2. for Bank 1:
   1. Install the mass air flow meter sub-assembly with the 2 screws.
   2. Connect the mass air flow meter sub-assembly connector.
      NOTE:

      • If the mass air flow meter sub-assembly has been struck or dropped, replace it.
      • If reusing the mass air flow meter sub-assembly, be sure to inspect the O-ring.
      • Make sure that the O-ring is not cracked or does not move out of place during installation.

Refer to PROCEDURE - Step 96 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 96 [06/2019 - 05/2023] , or refer to PROCEDURE - Step 100 [05/2023 - 09/2023] , or refer to PROCEDURE - Step 102 [09/2023 - ]

Refer to PROCEDURE - Step 14 [03/2017 - 04/2020] , or refer to PROCEDURE - Step 14 [04/2020 - 05/2023] , or refer to PROCEDURE - Step 15 [05/2023 - 09/2023] , or refer to PROCEDURE - Step 15 [09/2023 - ]

Refer to PROCEDURE - Step 8 [03/2017 - 05/2023] , or refer to PROCEDURE - Step 8 [05/2023 - ]

Refer to PROCEDURE - Step 9 [03/2017 - 05/2023] , or refer to PROCEDURE - Step 9 [05/2023 - ]

Refer to PROCEDURE - Step 10 [03/2017 - 05/2023] , or refer to PROCEDURE - Step 10 [05/2023 - ]

Refer to PROCEDURE - Step 138 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 138 [06/2019 - 05/2023] , or refer to PROCEDURE - Step 141 [05/2023 - 09/2023] , or refer to PROCEDURE - Step 147 [09/2023 - ]